DTV 742 User’s Manual
800057-01 Rev. B
16
2.3 DTV742 Connections
Figure 2.1 DTV742 System Setup shows placement of the DTV742 in a basic
system setup. Multiple RF inputs may be split from a single antenna or sepa-
rate antennas may be used. Although the figure shows only one antenna con-
nection, each enabled RF input must be connected to an antenna or splitter.
Figure 2.2 DTV742 Rear Panel illustrates details of the DTV742’s rear panel.
Figure 2.1 DTV742 System Setup
Figure 2.2 DTV742 Rear Panel
Before applying power, make the following connections to your DTV742
(refer to Table 3 for connector details):
a) Connect the chassis grounding screw to an earth ground before
connecting the power cord to the unit.
b) Connect the ATSC 8VSB signals from your antenna(s) to the
DTV742's RF IN ports(1, 2, 3, and 4).
c) Connect your downstream equipment to the ASI OUT 1, 2, 3, or 4 ports
as desired.
d) Connect your LAN line to the DTV742’s Ethernet port.
e) If desired, connect the Relays port to your equipment to provide contact
closures during alarms and warnings.
f) Finally, connect the supplied ac power cord to the DTV742’s IEC
receptacle and to a 90 to 132 Vac source.
Summary of Contents for DTV742
