Warning
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
Safety
. . . . . . . . .
. . . . . . . . . .
. . . . . . . . . .
. . . . . . . .
. . . . . . . . .
Read First
-
Avoid working alone so assistance can
be rendered.
-
Do not use test leads or the Tester if
they look damaged.
-
Do not use the Tester if the Tester is
not operating properly or if it is wet.
-
Use the Tester only as specified in the
Instruction card or the protection by
the Tester might be impaired.
-
Use extreme caution when working
around bare conductors or bus bar.
Contact with the conductor could
result in electric shock.
-
Do not use the Tester to measure volt-
ages in circuits that could be damaged
by the Tester’s low input impedance
(approximate 4K
Ω
)
-
Use caution with voltages above 30 V
ac rms, or 60 V dc. These voltages
pose a shock hazard.
Symbols as marked on the Tester
and Instruction card
Safety Information
To ensure safe operation and service of
the Tester, follow these instructions.
Failure to observe warnings can result in
severe
injury
or
death.
Risk of electric shock
See instruction card
DC measurement
Equipment protected by double or
reinforced insulation
<
Battery
Earth
AC measurement
Conforms to EU directives
E
Application around and removal
from hazardous live conductors is
permitted
Do not discard this product or
throw away
Power On / Off
•
The Meter displays Battery Capacity
when powering up. Please replace the
battery when 0% is shown.
Caution
The Tester powers up in
Ω
/ continuity
mode.
Self-Testing Aid
ACA
•
Do not measure while powering up, it
will cause Self-Testing failure.
Caution
Do not use the Meter when “FAIL” is
shown. Undiscovered failure could exist
even No “FAIL” is shown.
CAT.
Ⅲ
.600V
with respect to
earth for the jaw.
Barrier for
Hand Guard
Do not hold
the meter above
the Barrier
Fail of usage
Ready to use
Auto Hold Enable /
Disable
Auto Power Off Enable /
Disable
Clamp Multimeter
Card
PRO-90
Instruction
