WEG ECW500, User Manual

Page: 21 / 84

Errors, Warnings and Events
ECW500 | 13
Table 2.2 Warning list
WR000 Digital input did not receive complementary command
WR001 Problem on the configuration of the digital inputs
WR002 Incorrect command of the parallel or online digital inputs
WR003 Parallel command received with the ECW500 off
WR004 No online mode configured, but online command received
WR005 Increment and decrement digital inputs simultaneously triggered
WR006 Calibration executed with the ECW500 on
WR007 Excitation disconnected
WR008 Phase loss at the power terminals
WR009 Internal overheating
WR010 Terminal overvoltage
WR011 Terminal undervoltage
WR012 Excitation overvoltage
WR013 Excitation overcurrent
WR014 Underfrequency
WR015 Received command to reset parameters with the ECW500 enabled
WR016 Alarm reset is missing to execute the command
WR017 Analog input cable 4 to 20 mA broken
WR018 Autotuning execution fail
WR019 MAC address problem
WR020 WR034 Reserved
WR035 Feedback loss
WR036 Rotating diodes fault
WR037 PxQ curve configuration problem
WR038 Anybus offline
WR039 Anybus fault
2.3 EVENTS
Events, on the other hand, are normal occurrences and not harmful to the system operation, as a mode
transition, a received command and others.
Events are not indicated on the HMI, and only recorded in the event list.
Table 2.3 Event list
EV000 Excitation OFF
EV001 Excitation ON
EV002 Calibration of the analog input of +/-10 Vdc executed
EV003 Command of alarm reset received
EV004 Changed to MECC mode
EV005 LEOC limiter actuating
EV006 LEOC limiter stopped actuating
EV007 LUF limiter actuating
EV008 LUF limiter stopped actuating
EV009 Received command for resetting parameters to factory default
EV010 Calibration of the measurement of the excitation current executed
EV011 LTOC limiter actuating
EV012 LTOC limiter stopped actuating
EV013 Changed to MTVC mode
EV014 LEUC limiter actuating
EV015 LEUC limiter stopped actuating
EV016 Changed to online mode
EV017 Changed to parallel mode
EV018 Autotuning started
EV019 Autotuning finished with successful
EV020 Autotuning canceled by the user
EV021 Autotuning timeout
NOTE!
When a warning or error occurs, the HMI will periodically display the message "There are some
warnings or errors" until an alarm reset is executed.
You can set how long this message appears and how long it is hidden in the HMI Configuration
screen.