EOTec 2104 User Manual
Technical Specifications
Backplane Port: (10/100BaseTX)
Plug and play
Yes, with factory pre-configuration available for special
parameters
Cable requirements
Not applicable (no cable)
Max. cable distance
Not applicable (no cable)
SC or ST Fiber Ports: (100BaseF multimode or single-mode)
100BaseFX ports
2
Fiber port mode
Multimode (MM) or single-mode (SM)
Fiber port connector
Duplex SC or ST
Optimal fiber cable
62.5/125 µm for MM; 9/125 µm for SM
Center wavelength
1300 nm
TX output power
Contact your switch vendor
RX input sensitivity
Contact your switch vendor
Max. distance
(full duplex)
2 km with MM; 15 km with SM,
40 or 60 km with long haul SM
Full and half duplex
Software configurable
Ethernet compliance
100BaseFX
Eye safety
IEC 60825-1, Class 1; FDA 21 CFR 1040.10 and 1040.11
General:
Operation
Intelligent store and forward, non-blocking
Ethernet protocols supported
All IEEE 802.3
Typical latency for 10 Mbps
16 µs + frame time
Typical latency for 100 Mbps
5 µs + frame time
Varies on load
and settings
MAC addresses supported
2 K
Buffer memory
1 Mbits (128 Kbytes)
Buffer allocation per port
Automatic and dynamic
Memory bandwidth
3.2 Gbps for full-wire speed on all ports
Address learning
Automatic
Address aging
Remove old address after 300s
73