Page
8
of
16
Withdraw the pivot pin 761267 far enough to release the lever arm. (There is an M6 tapped
hole in the end of the pivot pin to assist in withdrawing this)
The lever arm can be moved upwards to separate it, with the anvil pin 761247, from the anvil
SSC6491. The anvil may now be slid out from the anvil guide bush.
Re-assembly is the reverse of the above process.
8.
REPLACEMENT OF THE CUTTING BLADE
First withdraw the anvil as described above.
Pump out the main ram until the blade spring pins 030636 can be seen in the opening of the
cutter body.
The three pins are ¼” (6.35mm) diameter and they should be knocked out enough to release the
blade.
