WEBTEC FlowHUB Series, User Manual

Page: 9 / 52

English
Menu structure - Set up level - General notes
Key
The value can be changed by pressing up or down key. Once the correct value has been achieved pressing the key
enters the value and returns to the main menu. Pressing the up or down keys for longer than 2 seconds will activate a
fast mode which will rapidly change the reading.
Setting switch delay level - this is displayed in seconds with a decimal point. Reading can be changed from 0.10 of a
second up to 10 seconds in 0.01 steps.
Setting switch flow level - the flow level at which the switch will operate can be adjusted from the minimum flow value
to the maximum flow value. These values are dependant on the model.
Set switch type - the switch can be configured to operate above or below the flow level set in the section above.
Set switch sense - the switch can be configured to be normally open or normally closed.
Set flow units - the displayed flow units can be configured to be litres per minute or US gallons per minute. If changed
all switch and analogue output settings will change
Set temperature units - the displayed temperature units can be configured to be degrees Celsius or Fahrenheit.
Set analogue full scale - the flow at which the FlowHUB will give a full scale analogue output can be configured to any
value within the flow range
Set password - the password to enter the setup menu can be changed to any value from 0001 to 9999.
Enter factory set up - only suitably qualified and trained personnel can enter this level - there are no additional user
features.
7