16
WWW.WEBER.COM
®
2) Remove the two screws that secure the control panel to the frame.
3) Remove the control panel. Tilt panel forward and lift up and away from grill.
Completely remove the control panel
(3)
from the cooking box assembly exposing the valves, burners, igniter, and manifold.
1
2
3
(1)
(2)
CHECK THE FLEXIBLE HOSE TO MANIFOLD CONNECTION
The natural gas hose has been attached during the manuafacturing process. We
do recommend that the hose to gas manifold connnection be leak tested, following
guidelines in this Owner’s Guide, prior to barbecue operation.
CHECK FOR GAS LEAKS
DANGER
Do not use an open fl ame to check for gas leaks. Be sure
there are no sparks or open fl ames in the area while you
check for leaks. Sparks or open fl ames will result in a fi re or
explosion which can cause serious bodily injury or death
and damage to property.
WARNING:
You should check for gas leaks every time you
disconnect and reconnect a gas fi tting.
Note: All factory-made connections have been thoroughly checked for gas leaks. The
burners have been fl ame-tested. As a safety precaution however, you should recheck
all fi ttings for leaks before using your Weber
®
gas barbecue. Shipping and handling may
loosen or damage a gas fi tting.
WARNING: Perform these leak checks even if your barbecue
was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush to apply it.
Make sure side burner is off (See LEAK CHECK PREPARATION). Remove valve
control knob and screws. Remove porcelain top.
To perform leak checks: Slide back the collar of the quick disconnect
(1)
. Push male
fi tting of the hose into the quick disconnect, and maintain pressure. Slide the collar
closed
(2)
. If it does not engage or lock, repeat procedure. Gas will not fl ow unless the
quick disconnect is properly engaged.
Turn on gas supply.
Check for leaks by wetting the connections with the soap and water solution and
watching for bubbles. If bubbles form or if a bubble grows, there is a leak.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
WARNING: Do not ignite burners when leak checking.
GAS INSTRUCTIONS
Summary of Contents for S-620/650
Page 5: ...5 WWW WEBER COM 5 EXPLODED VIEW S 620 VISION CLAT E DIAGRAMA DE DESPIECE S620_NG_US...
Page 7: ...7 WWW WEBER COM 7 S650_NG_US EXPLODED VIEW S 650 VISION CLAT E DIAGRAMA DE DESPIECE...
Page 10: ...10 WWW WEBER COM 6 7 8 ASSEMBLY ASSEMBLAGE ENSAMBLAJE 3 3...
Page 11: ...11 WWW WEBER COM 11 11 10 9 1 2 S 650 3 ASSEMBLY ASSEMBLAGE ENSAMBLAJE 2 2...
