B-2
Complete frame assembly
You will need: partial frame assembly, two frame
connectors, four 2 inch bolts, four nylon
washers and a 7/16 inch or adjustable wrench.
Hold one frame connector between the caster frame
and wheel frame. Add the nylon washer to the bolt.
Insert the bolt through the frame and screw into frame
connector. Tighten bolt with wrench.
Repeat procedure with the other frame connector.
(1)
(2)
Continue frame assembly
You will need: caster frame, wheel frame, four 1/2 inch
bolts, four nylon washers and a 7/16 inch or adjustable
wrench.
Place the caster frame onto the tabs of the left frame,
so that the swing table locking latch (1) is to the rear.
Place the wheel frame onto the tabs of the right frame,
so that the swing table locking latch (2) is to the rear.
The leg tabs must be on the inside of the frames.
Add the washers to the bolts. Insert the bolts into the
holes as shown,
do not tighten bolts on wheel
frame until a later step.
