WWW.WEBER.COM
®
16
PREPARING TO USE YOUR GRILL
7
6
5
4
3
8
1
2
CHECKING FOR GAS LEAKS (continued)
B) To check for leaks, wet fittings with the soap-and-
water solution,, using a spray bottle, brush or rag. If
bubbles form, or if a bubble grows, there is a leak.
Apply the soap-and-water solution, to the following
connections:
a) Regulator hose-to-bulkhead connection
(1)
.
b) Corrugated manifold hose-to-bulkhead
connection
(2)
.
c) Corrugated manifold hose-to-manifold
connection
(3)
.
For Spirit
®
grills with side burners:
d) Side burner hose-to-manifold connection
(4)
.
e) Side burner hose-to-valve connection
(5)
.
WARNING: If there is a leak at
connections (1, 2, 3, 4 or 5), turn off the
gas, tighten the fitting with a spanner,
and recheck for leaks with soap-
and-water solution. If a leak persists
after tightening the fitting, turn off
the gas. DO NOT OPERATE THE
GRILL. Contact the Customer Service
Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
f) Regulator-to-cylinder connection
(6)
.
g) Regulator hose-to-regulator connection
(7)
.
h) Valves-to-manifold connections
(8)
.
WARNING: If there is a leak at
connections (6, 7, or 8), turn off the
gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service
Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
C) When leak checking is complete, turn gas supply off at
the source and rinse connections with water.
NOTE: Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
Reinstall Control Panel
You will need: A Phillips screwdriver.
A) Align valve stems with holes in control panel. Position
top edge of control panel on tabs of frame assembly.
Push control panel down into position.
B) Fasten control panel with screws.
C) Place control knobs onto valve stems.
D) Connect the wires to the igniter button.
WARNING: Make sure that all parts
are assembled and hardware is fully
tightened before operating the grill.
Your actions, if you fail to follow this
product warning, may cause a fire,
an explosion, or structural failure
resulting in serious personal injury or
death as well as damage to property.
Now you are ready to use your grill.
Summary of Contents for E-220 CLASSIC
Page 34: ...WWW WEBER COM 34...
Page 35: ...WWW WEBER COM 35...
