Weber 660-LP, Owner'S Manual

Page: 10 / 168

10
Some LP tanks have differing top collar assembles . (The top collar is the metal
protective ring around the valve .) One series of tanks mount with the valve facing front
(1) . The other tanks mount with the valve facing away from the fuel scale (2) . Weber
recommends the use of cylinder manufacturer’s Manchester and Worthington, with a
47 .6 lb water capacity . Other cylinders may be acceptable for use with the appliance
provided they are compatible with the appliance retention means (see illustrations) .
The LP cylinder is installed inside the tank enclosure, on the tank scale (right side) .
A) Loosen cylinder lock wing nut . Swing cylinder lock up
(3) .
B) Turn the LP cylinder so the opening of the valve is either to the front or rear of the
Weber
®
gas barbecue .
C) Lift tank up into position on the tank scale
(4)
.
D) Swing the cylinder lock down . Tighten the wing nut .
Connect the hose to the Cylinder
A) Remove the plastic dust cover from the valve .
B) Screw the regulator coupling onto the tank valve, clockwise, or to the right . Hand-
tighten only (5) .
Note: This connection tightens clockwise and will not allow gas to flow unless the
connection is tight. The connection requires tightening by hand only.
m warninG: do not use a wrench to tighten the connection.
using a wrench could damage the regulator coupling and
could cause a leak.
GAS INSTRUcTIoNS
1 2
3 3
5
4