SRV
600i
13
1
2
1
1
Starting
After horizontal transport: Bring tamper into a vertical
position and wait several minutes until the engine oil
has collected in the lower area of the crankcase.
After the engine has warmed up, slide the choke lever (1)
to the left (open).
Bring the gas lever into full-throttle lock-in position.
Slowly tighten the handle (1) of the reversing starter (2) until
resistance is noticeable.
Allow the handle (1) to glide back into the initial position, and
then forcefully and completely pull it through with both hands.
Allow the engine to warm up for a few minutes.
When starting in enclosed spaces ensure adequate
ventilation – danger of suffocation.
Never use any starter spray.
Push the choke lever (1) to the right (close).
Short circuit button to position (I/ON)
Open the fuel cock (1).
The engine is equipped with an oil monitoring system.
The engine will not start if the oil level is too low.
