DVS 400 Fast Charging System Operation and Maintenance Manual
09190-W-03-01
Page 9 of 27
Webasto Charging Systems, Inc.
•
The charging leads must be capable of the full rated current of the DVS 400, and inspected frequently for wear,
cuts and abrasion. Do not use worn, damaged, undersized, or poorly spliced cable.
•
The DVS 400 power connector may be damaged by misuse or abuse. Frequently inspect the connector for
cracking, pitting of contacts, fraying of wires or signs of connector fatigue. Should any indication be present,
immediate replacement of the connector will be necessary.
•
Do not wear rings, watches, necklaces, tie clips, or conductive jewelry when working with batteries, as a short
circuit through conductive jewelry may cause severe burns.
DANGER
BATTERY GASES AND ELECTROLYTE CAN BE HAZARDOUS: Charging
batteries produces fumes and gases that may be hazardous.
•
Charging batteries may leak corrosive electrolyte that can cause skin and eye irritation and damage equipment
and clothing. Avoid contact and follow battery manufacturer’s recommended practices for cleaning the battery
pack.
•
Thoroughly wash all items brought into contact with battery electrolyte with a solution of baking soda and water.
•
Batteries produce explosive gases. Do not smoke, perform operations that cause sparking, or have an ignition
source near batteries.
•
Ventilate the area to prevent the buildup of fumes and gases.
WARNING
IMPROPER INSTALLATION CAN CAUSE FIRE
•
Do not install or place unit on, over or near combustible surfaces.
•
Do not install unit near flammables.
•
Do not block or filter airflow to the unit (allow minimum of 6” clearance around unit).
•
Ensure that the BMID is properly installed according to the BMID installation instructions.
•
Replace blown fuses only with same type and rating of fuse.
•
Do not overload building wiring - be sure power supply system is properly sized, rated and protected to handle
this unit. Use only on circuits provided with the minimum wire size specified in the installation section.
2.3
Technical Support
Call technical support any time a procedural question arises. DO NOT perform a procedure you do not understand.
Customer Service can be contacted during normal working hours (Pacific Standard Time) by calling:
866-POSICHARGE (866-767-4242)