Webasto BlueCool Classic Series, Installation Instructions Manual

Page: 25 / 40

Webasto BlueCool Classic Series PROGRAMMING
25
Table 4 Description of Programming Codes - setpoint at
15 °C (59 °F)
Code #
Factory
Setting
Description Optional Settings
Functions accessible when lowering the setpoint temperature to 15 °C (59 °F)
Code <0> 195V AC
for 230V
units
90V AC for
115V units
Low voltage cut-out value. Time delay is
5 seconds approx. i.e. the low voltage
situation will have to persist during more than
5 seconds before cut-out occurs. After cut-
out the electronic controller resets and will
start a new cycle. So a renewed attempt to
start the compressor will occur after approx.
90 seconds. During low voltage cut-out the
display panel will show the 3 letters <AAA>. Note: Compressor
manufacturers decline
all responsibility for
defects resulting from
operating the
compressors below
recommended
voltage levels.
Do not lower factory
settings.
Code <1> 00 Infrared remote control
00 = Infrared remote control disabled (in this
mode no interference is possible with other
Infrared commands)
01 = Infrared remote
control active
Code <2> 01 Blower type: Centrifugal or Crossflow.
01 = all blower models
Code <3> 01 Blower Settings:
01 = Uninterrupted blower operation
regardless of the thermostatic control
00 = Thermostatic
control of blower
operation, i.e. blower
operation will be
interrupted
thermostatically when
reaching the
appropriate setpoint.
Code <4> 01 Choice between integrated air sensor and
external air sensor:
01 = air sensor integrated in digital display
(no option from 2010 onwards)
00 = external air
sensor
Code <5> 00 Celsius or Fahrenheit display
00 = Celsius
01 = Fahrenheit
Code <6> 70 Setting speed level 5 (max.) 01 - 70
See note a).
Code <7> 40 Setting speed level 4 01 - 70
See note a).
Code <8> 35 Setting speed level 3 01 - 70
See note a).
Code <9> 29 Setting speed level 2 01 - 70
See note a).
Code <A> 23 Setting speed level 1 (min.) 01 - 70
See note a).