Web Mountain Technologies RUC-01, User Manual, Page: 36 / 100

Web Mountain Technologies Page 30
based upon sunrise or sunset. Notice that you can setup an event based upon some amount of
time before or after sunrise or sunset. If you select Actual time, then enter the actual time in a
24 hour format. If you select time before or after Sunrise, or Sunset, then you can enter up to
4 hours, 59 minutes as the offset. Here’s an example:
1. If you want to send out a command at a specific time, then enter the hour and minutes.
Notice that this is in a 24 hour format. So, if you want to send a command at 9:15 AM,
enter 9 for the hours and 15 for the minutes, and have Actual Time selected. If you
want to send a signal at 9:15 PM, then enter 21 for the hours and 15 for the minutes.
2. If you want to send a signal at sunrise, merely select Time before Sunrise and leave the
Hours and Minutes at 0. Or, if you want to send the signal 15 minutes before Sunrise,
set Hours to 0 and minutes to 15. With Time before Sunrise selected, the UPB signal
will be sent 15 minutes before sunrise.
3. Alternatively, if you want to send a signal sometime after sunrise, select Time after
Sunrise and enter in the hours and minutes you want.
4. Do the same thing if you want to send the signal at Sunset, before Sunset, or after
Sunset by selecting the appropriate item.
5. While you can’t see it from this screen, when Schedule is selected as the Receive
command type, you will get a three more options on the SEND command screen –
Home, Vacation, or Both. If you select Home on the Send screen, this trigger will only
run when the RUC is in the Home mode (as selected on the Device Configuration
screen). If Vacation is selected, this trigger will only run when the RUC is in the
Vacation mode, and likewise, if Both is selected, the trigger will run all the time.
NOTE: Sunrise and Sunset are calculated based upon the Latitude, Longitude, and
Time Zone entered in the Device Configuration page. You need to make sure these are
correct for your location in order for the correct sunrise and sunset to be calculated.
To setup a UPB Direct command as the trigger event, select UPB Direct from the dropdown,
then either enter in the serial string command as generated by the UPB command wizard, or
enter in your desired NID, DID (Device ID), and select your command from the dropdown, as
shown below. Do not enter in the start character (Control-T) or the terminating character (CR).