Weaver W10-HD, Installation & Operation Manual

Page: 37 / 40

34
VI. OPERATION INSTRUCTIONS
Please read the safety tips carefully before operating the lift
To lift vehicle
1.
Keep clean of site near the lift;
2. Position lift arms to the lowest position;
3. To shortest lift arms;
4. Open lift arms;
5. Position vehicle between columns;
6. Move arms to the vehicle’s lifting point;
Note: The four lift arms must contact the vehicle’s lifting point at the same time
where manufacturers recommended
7. Push button UP until the lift pads contact underside of vehicle totally. Recheck to
make sure vehicle is secure;
8. Continue to raise the lift slowly to the desired working height, ensuring the balance
of vehicle;
9. Push lowering handle to lower lift onto the nearest safety. The vehicle is ready to
repair.
To lower vehicle
1.
Be sure clear of around and under the lift, only leaving operator in lift area;
2. Push button UP to raise the vehicle slightly, and then release the safety device, lower
vehicle by pushing lowering handle.
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.
5. Turn off the power.
Note: In order to extend the service life of the cylinder and seals, raise the machine to
top at least once a day
VII. MAINTENANCE SCHEDULE
Monthly:
1.
Re-torque the anchor bolts to 150 NM;
2. Check all connectors, bolts and pins to insure proper mounting;
3. Lubricate cable with lubricant;
4. Make a visual inspection of all hydraulic hoses/lines for possible wear or leakage;
5. Check Safety device and make sure proper condition;
6. Lubricate all Rollers and Pins with 90wt. Gear oil or equivalent;