Quick Instruction
Anschließen leicht gemacht
11 of 26
Weatherdock AG Sigmundstraße 180 D-90431 Nürnberg
Tel.:+49 911 376638-30 www.easyAIS-IS.de
Set transmission data rate to 38400 Baud.
Configure the bits of the input port as follows: 8/N/1. If you have AIS
targets around, you will see the following data on your screen
!AIVDM,1,1,,A,13u?etPv2;0n:dDPwUM1U1Cb069D,0*24
in the HyperTerminals window.
If there are no AIS data around, while swtiching on we do send also
some control data out of the interface port. In the moment you are
switching on the easyAIS-IS, data are transmitted through the port and
you should see some data stream on your display too. This means the
data connection is correct.
1.6.
Technical data/Specification
■ 2 channel
parallel receiver with integrated splitter/amplifier
to receive AIS data on
161,975 MHz and 162,025 MHz Class A and Class B
■ Sensitivity:
-112 dBm (Therefore 3dB
better than the requirements for Class A receivers)
■ Channel spacing:
25 kHz
■ Frequency selective antenna splitter with
the possibility to connect to the easyAIS-IS:
-VHF Antenna, 50 Ohm, SO239
-VHF Radio 50 Ohm, SO239
- Regular radio: 50 Ohm, BNC for frequencies
from app. 150 kHz to 110 MHz, Gain max. 15dB
■ Power: 9 v
- 28 VDC, @ < 150 mA (Average of different modes)
■ NMEA 0183 output, message type VDM
■ USB output for direct connection to PC
■ Multiplex input for GPS data to pass through
upconverted GPS data from 4800 Baud to 38400 Baud
■
Ambient conditions: under deck, 0° C to 60° C
