We PROTEUS-III, User Manual

Page: 76 / 244

WIRELESS CONNECTIVITY & SENSORS
User manual Proteus-III
0x00:
Key is displayed to enter it on the central device, no action needed in this device
0x01:
Key is displayed, please confirm/reject it using a
CMD_NUMERIC_COMP_REQ
7.2.12. CMD_NUMERIC_COMP_REQ
Depending on the security settings of the peripheral, a passkey is displayed to confirm or reject
it.
In case of the "LescNumComp" mode, the central and peripheral output the passkey to their
host. Both hosts must reply with a
CMD_NUMERIC_COMP_REQ
message to confirm that both keys
coincide.
Format:
Start signal Command Length Status CS
0x02 0x24 0x01 0x00 1 Byte 1 Byte
Status:
0x00: The keys displayed on the central and peripheral device coincide, thus connection setup
can be continued
0x01: The keys displayed on the central and peripheral device do not coincide, thus connection
setup shall the canceled
Response (
CMD_NUMERIC_COMP_CNF
):
Start signal Command | 0x40 Length Status CS
0x02 0x64 0x01 0x00 1 Byte 1 Byte
Status:
0x00: Answer accepted
0xFF: Operation not permitted
7.2.13. CMD_GETBONDS_REQ
This command requests the MAC addresses of all bonded devices.
Format:
Start signal Command Length CS
0x02 0x0F 0x00 0x00 0x0D
Response (
CMD_GETBONDS_CNF
):
Start signal Command | 0x40 Length Status
#Devices
Payload CS
0x02 0x4F 2 Bytes 1 Byte 1 Byte (Length - 2) Bytes 1 Byte
The Payload sequentially lists the data of the bonded
#Devices
devices. It consists of
#Devices
times the following telegram (see example below).
Order code 2611011024000
74
Version 1.8 , July 2022 www.we-online.com/wcs