WDT GRANUDOS 10-S5, Operating Instructions Manual

Page: 26 / 29

GRANUDOS S5, control unit
Index: 02 Date modified: 11/05/2021 OI No.: BA SW 014-02 Granudos S5-Steuereinheit EN.docx Page 26 of 29
9.3 Commissioning protocol
The commissioning protocol can be found in the operating instructions for the dosing unit of the respective
dosing device in
Chapter : 9.3.

for Granudos 10-S5 + 15-S5, No.: BA SW 002

for Granudos 45/100-S5, No.: BA SW 003
9.4 Operation data sheet
During a “software update” , all parameters are reset to the ex-works setting. After an “update”, all parameters
must therefore be checked and readjusted to the pool. We therefore recommend that you enter the
optimised, pool-specific parameters in this list.
Settings menu Ex works setting Setting ranges Step during commissioning
Optimised during
operation
1. Chlorine/pH dosing
performance Date: Date:
Chlorine 15 seconds 1-15 seconds 1
pH (acid) 8 seconds 1-8 seconds 1
Cycle 30 seconds 30-360 seconds 30
Dosing time limit acid 0 0-100 minutes 5
Dosing time limit chlorine 0 0-100 minutes 5
2. Shock chlorination
Chlorine dosing
performance 50 % depending on the
technical
configuration 1
Acid dosing performance 50 % depending on the
technical
configuration
1
3. System  Password
Technician 0123 0000 – 9999 1
4. Dust extraction
Run-on 0 0 – 60
Flushing time 5 seconds 1 - 5 seconds 1
Flushing interval 0 h 0 – 48h 1
5. Delay booster pump
Delay time 120 seconds 0 - 120 sec 5
6. Configuration chlorine
Rotation speed dosing
screw depending on
design 12 – 60 rpm 1
Diameter dosing screw depending on
design 19 / 26mm 1
7. Configuration pH
Hose diameter depending on
design 0.8/1.6/3.2/4.8/ext
8. Control
Control PWM PWM, freq., manual
9. Invert the inputs
CCT OFF NO NO/NC
Dos CCT OFF NO NO/NC