This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation.
If this equipment causes harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
-
Reorient or relocate the receiving antenna.
-
Increase the space between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer, an experienced radio, or a TV technician for help.
-
Only a shielded interface cable should be used.
Finally, any changes or modifications to the equipment by the user not expressly approved by the grantee or manufactur-
er could void the user's authority to operate such equipment.
▶
DOC COMPLIANCE NOTICE
This digital apparatus does not exceed the Class A limit for radio noise emissions from digital apparatus set out in the
radio interference regulation of Canadian Department of Communications.
▶
CE COMPLIANCE
This monitor complies with the basic protection requirements of the Electromagnetic Compatibility
(EMC) Directive 2004/108/EC for electrical and electronic equipment imported into the European Union (EU):
The electromagnetic disturbance generated by the apparatus does not exceed the level specified in the harmonized
EMC Standards for this type of apparatus. It has a level of immunity to the electromagnetic disturbance to be expected in
its intended use, and should operate without unacceptable degradation of its specified performance.
Back View of Monitor
Connector Panel is located on the underside of the case rear
projection, just above the stand
Use ONLY a properly grounded three
wire cord appropriate for the local
power system.
Connections
FCC RF Interference Statement
Summary of Contents for OE-19LED
Page 1: ......
