Operating Instructions and Parts Manual
7
WWB 2
PUMP OPERATION (CONT’D)
7. Always know where your discharge hose is placed. An
unsecured discharge hose may move or whip when
the pump is turned on.
8. Plug the power cord into a grounded 120 VAC GFCI
protected power outlet. Make sure the electrical outlet
is grounded and is rated for at least 15 amps. The
pump will start operating as soon as the power cord is
plugged into the power outlet.
9. The pump will remove water down to approximately
1/16 inch of the surface the pump was placed on.
Removing water down to 1/16 inch is based on many
factors. For pump to remove water as low as possible
the pump must be on a level surface.
10. The pump should be unplugged once the water is no
longer being moved, or pump will run dry.
PUMP RESET
If the pump runs dry, the pump will shut off. A hard reset is
required.
To reset the auto off function of the waterbug2, follow the
steps below:
A. For standard resetting, unplug pump and wait
approximately 1 hour.
B. For rapid reset, unplug pump, submerge in cold water,
and wait approimately 15 minutes.
C. Remove from water then plug to a grounded outlet, to
verify it has reset.
D. If pump does not reset, unplug and wait 5 minutes,
then repeat step C.
Do not allow pump to run dry. The shaft seal
depends on water for lubrication. Operating the pump without water
will damage the shaft seal and cause pump failure.
When the water level is approaching the
minimum pumping limit (1/16 inch), the water removal rate
may slow, and the pump may become more noisy. This is
due to air being drawn into the pump in addition to water.
During this time the pump may still remove water. Once
water has stopped coming out of the hose unplug pump to
avoid running dry.
When routing the electrical cord protect cord
from sharp objects, hot surfaces, oils, and chemicals. Do not kink cord,
do not use with damaged cord.
MAINTENANCE
Disconnect power before servicing. Improper
use could result in death or serious injury.
Débrancher l’alimentation avant de procéder
à l’entretien. Une utilisation incorrecte peut entraîner la mort ou des
blessures graves.
1. Keep pump inlet clean and free of all foreign objects.
Inspect inlet at beginning of each use.
2. The motor housing is completely sealed and requires
no service. Disassembly of the motor housing or
alteration of the power cord could result in fatal
electrical shock and will void warranty.
SERVICE AND REPAIR
Service work on this pump must be performed
by qualifi ed repair personnel. ONLY use identical WAYNE replacement
parts.
When servicing this pump, only identical
WAYNE replacement parts should be used. Failure to follow these steps
may create a risk of fl ooding, property damage, fatal electrical shock, or
other serious injury.
Lors de l’entretien de cette pompe, seules des
pièces de rechange originales de WAYNE doivent être utilisées. Le non-
respect de ces étapes peut entraîner un risque d’inondation, de dégâts
matériels, de choc électrique mortel ou d’autres blessures graves.
NOTE:
Debris filter will not protect pump from all debris.
If reduced performance is noticed it may be necessary to
clean the volute and impeller.
VOLUTE AND IMPELLER CLEANING
a. Unplug pump
b. Remove inner 6 screws shown in (Figure 1), do not
remove the outer screws!
c. Remove volute and clean impeller and volute
of all debris.
d. Reposition cork gasket using alignment
features taking care not to obstruct pump
discharge openings.
e. Reinstall volute using caution not to
overtighten or strip screws or screw bosses.
Figure 1
OUTER SCREWS
(DO NOT REMOVE)
INNER SCREWS