23
INITIAL BURNER START UP PROCEDURE
READ THE APPLICATICABLE SEQUENCE OF BURNER/PRIMARY GAS
CONTROL OPERATION IN SECTION V SERVICE AND TROUBLESHOOTING BEFORE
PROCEEDING.
1.
Depress the combination gas valve manual control knob and turn to “OFF” position. (For location of
the manual control knob, refer to Figure 17). Remove the 1/8” NPT pressure tap plug from the gas
valve and install a hose barb fitting. Connect a manometer to the hose barb fitting.
2. Adjust the primary air and off-cycle damper to the start-up settings shown in Figure18.
Figure 18: Air Settings for Initial Start Up
Figure 19: Primary Air and Off Cycle Damper Locations
Primary Air Location
Off Cycle Damper Location
Summary of Contents for HSG200
Page 30: ...30 Figure 20 Flame Current Measurement Top Wayne control Bottom Honeywell control...
Page 48: ...48 Figure 29 continued Junction Box Assemblies Exploded Figure 30 Motor Assembly Exploded...
Page 49: ...49 Figure 31 Gun Assembly Exploded Figure 32 HSG Series Burner Exploded...
Page 52: ...52 NOTES...
