11
Tools Needed:
Please Do Not return This Product To The Store.
Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section
online at www.Wayne-Dalton.com
Installation
IMPorTANT:
REaD INsTRuCTIONs TITlED “P4” “REMOVING THE OlD DOOR” ON PaGE 9 aND “P5” “PREPaRING THE OPENING” ON
PaGE 10 BEFORE aTTEMPTING DOOR INsTallaTION.
IMPorTANT:
sTaINlEss sTEEl OR PT2000 COaTED laG sCREWs MusT BE usED WHEN INsTallING CENTER BEaRING BRaCkETs,
END BRaCkETs, jaMB BRaCkETs, OPERaTOR MOuNTING/suPPORT BRaCkETs aND DIsCONNECT BRaCkETs ON TREaTED luMBER
(PREsERVaTIVE-TREaTED). sTaINlEss sTEEl laG sCREWs aRE NOT NECEssaRy WHEN INsTallING PRODuCTs ON uN-TREaTED
luMBER.
NoTE:
It is recommended that 5/16” x 1-5/8” lag screws be pilot drilled using a 3/16” drill bit, and 1/4” x 2” lag screws and
1/4” x 1-1/2” lag screws be pilot drilled using a 1/8” drill bit, prior to fastening.
INST
ALLA
TI
oN
None
Attaching quick Install flag
Angle to Vertical Track
NoTE:
If you have fully adjustable
flagangle, skip this step and complete
step 2.
Place the lower quick install tab of the
flagangle in the quick install feature of
the vertical track. Give the flagangle 1/4
turn to lock in place. Repeat for other
side.
NoTE:
after completing this step,
continue with step 3.
quICk INsTall TaB uNlOCkED
quICk INsTall TaB lOCkED
FlaGaNGlE
VERTICal
TRaCk
1
lEFT HaND TRaCk aND FlaGaNGlE
RIGHT HaND TRaCk aND FlaGaNGlE
FlaGaNGlE
VERTICal
TRaCk
