356914-0004 REVC 04/06/2020
11
©Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation
FASCIA
HOOD
SCREWS
#10 TEK
SCREWS
#10 TEK
HEAD ASSEMBLY
WINDING DIRECTION
(SOME COMPONENTS NOT
SHOWN FOR CLARITY)
CURTAIN
HEADPLATE
WRAP
GUIDE
CURTAIN
WINDING
NUT
FIG 19A
FIG 19B
FIG 21
BOTTOM BAR
STOPPER
CURTAIN
GUIDE
FIG 20A
FIG 20B
Prior to winding or making adjustments to the springs, ensure you are winding in the proper direction as stated in the installation instructions. The spring fittings may
release from spring if not wound in the proper direction and could result in severe or fatal injury.
WARNING
WARNING
Winding torsion spring(s) is an extremely dangerous procedure and should be performed only by a trained door system technician using proper tools and instructions.
WARNING
WARNING
Rapidly closing curtain could result in death or serious injury. Use caution when lowering curtain before spring tension is applied.
WARNING
WARNING
• Cut the banding and carefully lower the curtain into the guides to
the fully closed position.
• Using a 1-1/2” open end wrench wind the spring by turning the
Winding Nut the specified number of turns indicated on your
door drawing sheet. The winding direction would be the same as
the direction to open the door for both left and right hand drive.
See FIG 19A and 19B.
• Check the balance of the door. If needed raise the door and adjust
the number of turns to achieve proper balance.
STEP 2
STEP 2
WIND SPRINGS (SKIP THIS STEP IF YOUR DOOR IS
ELECTRICALLY OPERATED)
• Cut the banding and carefully lower the curtain into the guides to the fully closed position.
• With door in the closed position attach stopper using stud plate and nuts provided, as shown in FIG 20A and FIG 20B.
STEP 3
STEP 3
ATTACH BOTTOM BAR STOPPER
• Position hood and fascia in place as shown in FIG 21.
• Align the hood and fascia and attach using the #10 tek screws provided. See FIG 21.
• If your door is 12’-0” or wider you must also attach the hood to the hood band, supporting the center of the hood with #10
tek screws provided.
STEP 4
STEP 4
ATTACH FRONT HOOD AND FASCIA
