356914-0004 REVC 04/06/2020
10
©Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation
SUPPORT
BAR
GUIDE
CURTAIN
HEAD
ASSEMBLY
FIG 15
GUIDE
CURTAIN
ASSEMBLY
HEAD
GUIDE
CURTAIN
JAMB
FIG 16
GUIDE
CURTAIN
FASTENERS
WALL
JAMB
CURTAIN
WRAP
FIG 17
FLUSH WITH
OUTER SURFACE
JAMB
WALL
FASTENER
CURTAIN
GUIDE
FIG 18
BETWEEN JAMB INSTALLATION
• Lift head assembly with fork lift and insert both support bars into curtain guides. See FIG 15
• Using the fork lift and two assistants, slide the whole assembly into place between the jambs until the guides are fl ush with the jamb surface at the front of the door. See
FIG 16
• Check “G” Dimension as illustrated in Fig 4 on page 5. “G” Dimension must match your “DOOR INSTALLATION DATA” sheet.
• Both guides MUST be on a level line and both guides MUST be plumb.
• Be sure there is a small gap between the top of the headplates and the header for attaching the hood and fascia in a future step.
• The “Guide Dimension” must be held within 1/8” over the entire height of the guides.
• Mount curtain guides to the wall surface using supplied fasteners. See FIG 17 and 18
STEP 1
STEP 1
INSTALL CURTAIN GUIDES AND HEAD ASSEMBLY
Follow instructions and use proper lifting equipment and correct lifting procedure to avoid serious injury or death.
WARNING
WARNING
Rapidly closing curtain could result in death or serious injury. Do not remove factory binding around curtain assembly until step 2.
WARNING
WARNING
