8.
9.
LeakSmart Water Heater Kit
LeakSmart Water Heater Kit
5.
Mount the LeakSmart Control Panel in an easily
accessible location within 30 inches of the LeakSmart
Valve. You may mount the panel using the screws and
anchors or Hook & Loop Mounting Pad provided.
When using the Hook & Loop Mounting Pad, make sure the
adhesive is put on a clean, dry surface.
NOTE:
Depending on the location you pick, and the distance
between the Control Panel and the LeakSmart Valve, you
may need to purchase a LeakSmart Control Panel to Valve
Extension Wire, Model # 8821200 ( sold separately, available
where you purchased your LeakSmart System). The extension
wire can extend the length of the LeakSmart valve wire by
approximately 9 feet.
6.
With the contacts of the wire harness connector facing
you, plug the 4-pin connector end of the Wire Harness
into the bottom of the Control Panel.
5.
6.
Installation Instructions:
Installation Instructions:
7.
Take the short round wire coming from the Control
Panel and plug it into the wire coming from the
LeakSmart Valve. Make sure the arrow on the
side of each plug lines up with each other.
NOTE:
The LeakSmart Water Leak Sensor comes with a
paper sleeve. If the Leak Sensor is going to be placed in
a metal water heater pan, make sure you leave the paper
sleeve on. If the Leak Sensor makes contact with metal,
it will signal the LeakSmart Valve to shut off. The paper
sleeve acts as a barrier between the Leak Sensor and the
metal. When the paper sleeve becomes wet, it will signal the
LeakSmart Valve to shut off. If the Leak Sensor will not be
contacting metal, you may remove the paper sleeve.
8.
Connect plug on end of long flat wire coming from
Control Panel to either set of prongs on the Leak
Sensor, pushing until plug snaps in place. Then place
Leak Sensor on the floor next to the water heater,
preferably on the side that is in line with the floor drain.
NOTE:
Additional Water Leak Sensors (sold separately) can
be connected together for added protection. For additional
Leak Sensors, purchase LeakSmart Water Leak Sensor,
Model #8820700 (available where you purchased your
LeakSmart System).
CAUTION:
Do not place Leak Sensor or cord in a walk way
or other location that may cause someone to trip and fall.
7.
8.
