Wavetek XP Series, User Manual

Page: 10 / 22

8
Product Maintenance
Cleaning
To clean the meter, use a soft cloth moistened with water. To avoid damage to the
plastic components do not use benzene, alcohol, acetone, ether, paint thinner,
lacquer thinner, ketone or other solvents to clean the meter.
Troubleshooting
If the meter appears to operate improperly, check the following items first.
1.
Review the operating instructions to ensure the meter is being used properly.
2. Inspect and test the continuity of the test leads.
3. Make sure the battery is in good condition. The low battery symbol
M
appears when the battery falls below the level where accuracy is guaranteed.
Replace a low-battery immediately.
4. Check the condition of the fuses if the current ranges operate incorrectly.
Battery and Fuse Replacement See Figure -14-
XW
WARNING
To avoid electrical, shock remove the test leads from both the
meter and the test circuit before accessing the battery or the
fuses.
To replace the fuse:
1.
Remove the 2 rear-case screws.
2. Separate the case.
3. Remove and replace the 2 A fuse (15XP or 35XP) or 0.315 fuse (5XP).
4. Reassemble the meter.
Fuse:
Fast Blow 2 A/1000 V, minimum interrupt rating 30 kA (6 x 32 mm)
(Meterman FP200).
Fast Blow 0.315 A/1000V minimum interrupt rating 30 kA (6.3 x 32 mm)
(Meterman FP300)
WARRANTY
The XP Series of Digital Multimeters are warranted against any defects of material
or workmanship within a period of one (1) year following the date of purchase of
the multimeter by the original purchaser or original user. Any multimeter claimed to
be defective during the warranty period should be returned with proof of purchase
to an authorized Meterman Test Tools Service Center or to the local Meterman Test
Tools dealer or distributor where your multimeter was purchased. See Repair
section for details. Any implied warranties arising out of the sale of a Meterman
Test Tools multimeter, including but not limited to implied warranties of
merchantability and fitness for a particular purpose, are limited in duration to the
above stated one (1) year period. Meterman Test Tools shall not be liable for loss of
use of the multimeter or other incidental or consequential damages, expenses, or
economical loss or for any claim or claims for such damage, expenses or
economical loss. Some states do not allow limitations on how long implied
warranties last or the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.