14
SETTINGS SCREEN
1. Press to access the Settings Screen.
2. Press the
Display
value to cycle through the
display and control temperature units available
- Celsius (°C), Fahrenheit (°F), Kelvin (K) or
Sensor Raw.
3. Press either
Tolerance
value and turn the adjustment
knob until the desired tolerance window is displayed. A
green target symbol will show on the front panel when
the actual temperature is within the window defined by
setpoint ± the tolerance for the specified amount of time.
4. Move the slider bar on the touchscreen to change the
Display Brightness
.
5. Press the blue text to toggle the
Beeper
setting.
Figure 19. Settings Screen
SAVE/RECALL OPERATIONAL
PARAMETERS
1. Access the Settings Screen.
2. Press to access the Save/Recall Screen.
3. Under
Save Settings to
, press
the blue text to toggle through the
Profile options, select one, and
then press the
Save
icon.
The following operational parameters are saved:
TC PARAMETERS
LD PARAMETERS
Tune Mode
Control Mode
Temperature Setpoint
Laser Setpoint
Current Limit, Negative
Current Limit
Current Limit, Positive
Max Laser Voltage
Sensor
PD Range
Sensor Bias Current
PD Transfer Function
High Temperature Limit
PD Bias Voltage On/Off
Low Temperature Limit
On Delay Time
Proportional Gain
Cable Resistance
Integrator Time Constant
Laser Type
Differentiator Time Constant
Tolerance
Temperature Units
Cable Resistance
Voltage Limit
GENERAL PARAMETERS
Beeper Mute Status
Display Brightness
Under
Recall Settings from
, press the blue text
to toggle through the saved Profile options, and
then press the
Recall
icon to recall the saved
settings. Select Factory Profile to restore the settings to the
factory defaults. Note that the Factory Profile is not editable.
Profile names can be set via remote command.
Figure 20. Save / Recall Screen
