15
09
Getting the parts set up
Refer to the diagram to the right as needed
1
Secure your outdoor MIMO panel antenna to your mount if you haven’t already,
and install it outdoors in the antenna position which you found using the method
described in section 3.
2
Connect each port of the outdoor MIMO panel antenna to the included 5’ jumper
cables and lightning surge protectors. Instructions on grounding are in the next
section of the manual.
3
Connect the large N-type ends of one of your twin RS240 coax cables to each of the
lightning surge protectors and hand tighten it.
4
Connect the smaller SMA-type ends of your twin RS240 cable to the outdoor antenna
ports on each of your GO X boosters and hand-tighten them. Note the two icons by
the Cel-Fi GO X’s two SMA antenna ports:
This port should be connected to the outdoor antenna.
This port should be connected to the indoor antenna.
4
Connect the SMA ends of your second twin RS240 cable to the indoor antenna ports
on your two GO X boosters and hand-tighten them.
3
Connect the N-type ends of this twin RS240 cable to each port of the indoor MIMO
panel/dome antenna and hand-tighten the connectors.
Assembling the J-Mount and Antenna
The photo to the right shows how the Outdoor Antenna should be
secured to the included Antenna Mount.
If you’d like more detailed instructions on how to install the L-bracket to
the antenna mount, you can fi nd that online here:
waveform.com/polemount-instructions
Assembling Your Kit
