9
Understand How The GO X Works
04
The GO X “Searches” For Signal
Unlike other boosters, the GO X doesn’t blindly amplify every frequency. Instead, it
searches
for, and then amplifi es, the best signal available for your carrier.
At any given time, the GO X can amplify up to two frequency bands.
In the Wave mobile app, you can watch in the “Advanced” tab as it scans the frequencies on
different bands to fi nd the best signal to amplify.
Anytime you power-cycle one of your GO X's, connect or disconnect the outdoor antenna,
change the band settings, or change the operator, it will restart scanning to fi nd the best
signal. To make sure it scans all frequencies,
restart both GO X units anytime you disconnect
and then reconnect the outdoor antenna
.
Activity Lights
A small light on each GO X fl ashes to indicate the booster's current status.
Solid Green:
The GO X has found the best band and is amplifying your signal.
Blinking Green:
The GO X is scanning for networks to boost.
Blinking Red:
The unit is in an error condition. Check the app for more information.
Solid Red:
If the status light remains red, the device has a hardware issue. Call us for a
replacement.
Boot-up Sequence
On being plugged in, the GO X activity light will start solid red, then fl ash red, then move on
to blinking green as it starts scanning the cellular frequency bands. Make sure the outdoor
antenna is connected to the
port before powering on so the GO X can fi nd signal.
Finally, once the GO X has found signal to boost, the activity light will switch to solid green.
