P.
9
www.wavecontrol.com
User’s Manual
Personal equipment WaveMon
When it is switched on, the
WaveMon
will show
the strength of the present electric or magnetic
field by means of signal lamps. The ambient
field strength is shown as a percentage of the
regulated limit. The signal lamps show the
maximum levels of the instantaneous electric and
magnetic field, but the record of both is stored in
memory.
Bear in mind as well that the average field value,
based upon the instantaneous field, is stored in
memory to allow analysis of your exposure in
respect of international standards.
Note:
the magnetic field is not available on some
models. See Section 12.
The user can learn the field strength by observing
the number of blinking lights. Field strength
indication starts when it is over 10% of the
established limit. A colour code is also used so
that the user does not have to focus continually
on the device.
If the field strength is lower than 50% of the limit,
the lights showing the present field strength will
blink green. If the field strength is higher than
50% but lower than 100% of the limit, the lights
showing the present field strength will blink
orange. When the field strength is over 100% of
the limit, the lights will blink red.
To ensure that the user is aware of the presence
of a strong field, the device will also give audible
and vibratory warnings when the threshold
defined by the user is exceeded.
Note:
the device will continue measuring and recording
the electromagnetic field even after a fall is detected.
5.
FALL WARNING
The
WaveMon
is equipped with a fall sensor and
if it detects such an event, the device will begin
beeping until it is switched off. This feature makes
it possible to warn others nearby instantly if
someone carrying a
WaveMon
falls.
