Wavecom WISMO Pac P5100 Series, User Manual

Page: 38 / 42

E
RROR
! R
EFERENCE SOURCE NOT
FOUND
. P5186 U
SER
M
ANUAL
V 1.0
Error! Reference source not found.
6.2 Trouble shooting
If I=0 on the external power supply amperemeter, then:
o
Check that the external power supply:
Is “ ON ”.
is connected on J200.
is adjusted for an output voltage between 3.2 V and 4.2 V.
o
Check that the “ON/OFF” switch ( SW201 ) is “ON”.
o
Check the fuse F1 (3 A) and replace it if necessary.
Note: technical characteristics of the fuse to be replaced are given in appendix.
o
Check the configuration of the jumpers on switch SW200 .
If the WISMO module does not reply to the “ AT
↵
” command (no message “OK” is
received), make sure that:
o
The WISMO module is present on the mother board (socket up mounted).
o
a software has been loaded in the module (refer to the documentation [3]) .
6.3 Safety, FCC and Industry of Canada Regulatory compliance
6.3.1 RF safety
6.3.1.1 General
Your GSM terminal
1
is based on the GSM standard for cellular technology. The GSM standard is
spread all over the world. It covers Europe, Asia and some parts of America and Africa. This is the
most used telecommunication standard.
Your GSM terminal is actually a low power radio transmitter and receiver. It sends out and receives
radio frequency energy. When you use your GSM application, the cellular system which handles
your calls controls both the radio frequency and the power level of your cellular modem.
6.3.1.2 Exposure to RF energy
There has been some public concern about possible health effects of using GSM terminals.
Although research on health effects from RF energy has focused on the current RF technology for
many years, scientists have begun research regarding newer radio technologies, such as GSM.
After existing research had been reviewed, and after compliance to all applicable safety standards
had been tested, it has been concluded that the product was fitted for use.
If you are concerned about exposure to RF energy there are things you can do to minimize
exposure. Obviously, limiting the duration of your calls will reduce your exposure to RF energy. In
addition, you can reduce RF exposure by operating your cellular terminal efficiently by following the
below guidelines.
confidential ©
Page :
38 / 42
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written
agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son
autorisation préalable.
1
based on WISMO2D