WM_PRJ_M12_UGD_001 - 002
18th September 2003
confidential ©
Page :
33 / 38
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à
des tiers sans son autorisation préalable.
Error
Code
Diagnostic Hint
112
Location area not
allowed (#12)
No action.
113 Roaming
not
allowed in this
location area (#13)
No action.
132 Service
option
not
supported (#32)
Check the service option.
133 Requested
service
option not
subscribed (#33)
Call your network provider to subscribe to the
requested service option.
134 Service
option
temporarily out of
order (#34)
No action.
148 Unspecified
GPRS
error
No action.
149 PDP
authentication
failure
Call your network provider to know the right
authentication parameters.
150
Invalid mobile class
Change the class of the mobile to a valid one.
Note: For all other codes, and/or details, refer to AT commands documentation.
6.3 Receiving “No carrier” message
If the Fastrack modem returns a message of No carrier upon an attempted
transmission of data, or voice signals, then refer to the table below for possible
causes and solutions.
Table 16:
Solutions for “No carrier” message
If the modem
returns…
Then ask…
Action…
Is the received signal strong
enough?
Refer to paragraph 4.3 to
verify the strength of the
received signal.
No carrier
Is the antenna properly
connected?
Refer to paragraph
3.3.2.3 for antenna
requirements.
No carrier (when
trying to issue a
voice
communication)
Is the semicolon (;) entered
immediately after the phone
number in the AT command?
Ensure that the
semicolon (;) is entered
immediately after the
phone number in the AT
command.
e.g. ATD######;
