9
Operation
Power On
Connect the WaveBox to a single power source of your choice:
AC:
Plug into any standard 120V, 60Hz grounded AC power outlet. This power source
delivers optimum performance.
-OR-
DC Battery direct connect:
Use ONLY the supplied DC direct connect cable with
“alligator” clips to connect direct to any 12V automotive or marine type battery. This
power source delivers optimum performance.
-OR-
DC power outlet connect:
Use ONLY the supplied DC power outlet cable to connect
thru any standard 12V power outlet(20A minimum) or “cigarette lighter connection” in
your vehicle. This power source is very convenient, but sacrifices some cooking speed.
NOTE: A SPARK MAY OCCUR WHEN CONNECTING THIS MICROWAVE TO
A POWER SOURCE. THIS IS A NORMAL PHENOMENON AND DOES NOT
INDICATEA DEFECTIVE APPLIANCE.
Please only connect to a DC power outlet rated at 20amps or higher. Information on the
amp rating for all your vehicle’s power outlets can be found in the users manual under “fuse
diagram”.
The WaveBox is built to be operated with the vehicle running to reduce the risk of
unintended battery drain, and to deliver maximum cooking power.
NOTE:
Do not connect the
WaveBox
®
to more than a single power source at any given
time. It will not operate. After connecting your WaveBox
®
to a single power source, the
unit will beep to let you know it is ready for use, displaying zeros in the display window.
The WaveBox
®
is now ready for operation.
NOTE
:For DC operation be sure to maintain correct polarity.The WaveBox will not
operate with reverse polarity.To rectify,simply connect using correct polarity.Red alligator
clip to positive (+)battery post,and Black alligator clip to negative(-)battery post.
Some foreign cars and trucks employ a positive ground design.The WaveBox will
not operate using a positive ground connection.If in doubt,consult with your vehicle's
dealership.
When connecting to an automobile,small truck, boat or van,the engine should be running
in order to prevent discharge of the battery to a point where the vehicle will not start.
Connect the alligator clips to the vehicle's battery,start the vehicle's engine,and then
operate the WaveBox.To disconnect the WaveBox,shut off the vehicle's engine,and remove
the alligator clips from the vehicle's battery.Do not connect or disconnect the alligator
clips with the engine running.
When connecting to large trucks,motor homes or buses the unit may be used without
running the engine.
CAUTION:NOT FOR USE IN AIRCRAFT.
