NOTE: If there are areas in the water that cause a false Dangerous Submersion Alert
when the wearable is not submerged, it is then necessary to find an alternative
location for the Hub or address any object(s) that may be causing the issue.
If the system is moved repeat the above test until you are completely confident that
the entire swim area is fully covered
.
ACTIVE MONITORING
After successfully confirming that the system completely covers the swim area, you are now
ready to start using your Hub for active monitoring.
1.
Power on the Hub using the Start Up Process.
2.
Use the WAVE Management App to change/confirm settings
3.
Check for system notifications and take any required actions as necessary.
4.
Distribute only ENABLED wearables to all swimmers and non-swimmers.
IMPORTANT:
Always maintain vigilance and follow all standard safety protocols around water.
AFTER USING THE WAVE SYSTEM
1.
Always inspect water to confirm that all swimmers have safely exited.
2.
All wearables should be accounted for and returned.
3.
If battery power is used, recharge the Hub.
4.
Clean and dry Hub if required, wiping down with damp soft cloth*.
5
.
While cleaning occasionally inspect the Hub for any signs of damage.
6.
Occasionally inspect each wearable for signs of damage.
7.
Store the Hub in a dry secure location.
* Do not use ammonia based cleaning products as these may damage plastics over time.
WAVE Systems Commercial User Guide v021221.1
Page of
34
40
Summary of Contents for w100
