POWERING & CHARGING YOUR w10 Hub
The w10 Hub may be powered via the internal battery
or the AC Charging/Power Adapter. The standard
battery will last up to 6 hours of typical use*.
Fully charging the battery normally takes a few hours.
After this initial set up process you may view the
Hub’s battery level at any time by using the WAVE
Management App (see below).
START UP PROCESS
Press the Power Button to initiate the startup process. After
a few seconds the LED on the Power Button will glow green, the Strobe will light up in a chase
pattern, and depending on your software version installed, a tone may sound. Once the start
up process is complete (typically up to 2 minutes), the Strobe will begin a slow fade in/fade out
pattern to indicate that the Hub is on.
POWER DOWN PROCESS
Press and hold the power button down for approximately 5 seconds to power down the w10.
The green LED on the Power Button will turn off. Depending on the system software version
installed in your w10, it may sound a tone and the Strobe will light in a pattern during the shut
down process.
WAVE w10 Swimmer Safety System User Guide v0721-1
Page of
8
27
Power/Charging Port
Power Cord
AC Charging/
Power Adapter
Power
Button
Strobe
