IMPORTANT:
Always maintain vigilance and follow all standard safety protocols around
water. Never rely solely on the w10 system.
AFTER USING YOUR w10
1.
Always inspect water to confirm that all swimmers have safely exited.
2.
All wearables should be accounted for and returned for storage.
3.
Power down the w10 using Power Down Process.
4
.
If battery power is used recharge the system.
5.
Clean and dry system if required, wiping down with damp soft cloth*.
6
.
While cleaning occasionally inspect system for any signs of damage.
7.
Occasionally inspect each wearable for signs of damage.
8.
Store the w10 in a dry location. Use the Wall Mount only if it is installed in a protected area.
* Do not use ammonia based cleaning products as these may damage plastics over time.
TROUBLESHOOTING
System does not power on.
1.
Confirm that you followed the steps in POWERING AND CHARGING YOUR w10 Hub section.
2.
If the w10 determines that its batteries are too low it may automatically power down the system to protect the
batteries and electronics. Connect the AC Charging/Power Adapter to the w10 Hub and plug the Charger into a wall
outlet. After approximately 30 minutes try powering on the Hub again. Check battery level and continue charging
unit the battery level is 100%.
System goes into alert with no active wearables.
1.
Scan the water immediately to confirm that there is no one (or pet) in the water. Glare, surface distortions, blind
spots, etc. may prevent you from seeing the possible victim.
2.
Scan the water to make sure that no wearable is fully submerged under water.
3.
Restart the w10 following the steps in POWERING AND CHARGING YOUR w10 Hub section.
4.
If restarting the w10 does not solve the issue, move the w10 to a new location (see UNDERSTANDING WHERE
TO PLACE THE w10 HUB section).
WAVE w10 Swimmer Safety System User Guide v0721-1
Page of
23
27
