Troubleshooting:
Fault
Probable Cause
Solution
Water changes color or becomes cloudy.
Rower is in direct sunlight or has not had
water treatment.
Change rower location to reduce direct
exposure to sunlight. Add water
treatment and blue dye or change tank
water as directed in the water treatment
section of this manual.
Rower belt slipping off belt/ bungee pulley.
Bungee not under enough tension.
Tighten bungee cord following the
instructions in "Replacing the
bungee/shock cord" section of this
manual.
Front of rower lifts slightly during vigorous
rowing.
M10X180mm main seat rail bolt is slightly
too loose.
Tighten bolt 1/2 turn and row again.
Tighten as needed until problem stops.
Note: Over tightening this bolt can
damage the seat rail. Only tighten bolt
in small increments until fault is
corrected.
The Pacific Rower computer does not
illuminate after battery installation.
Batteries installed incorrectly or need
replacing.
Reinstall batteries in correct position
and try again. If the LCD screen fails
to illuminate, try rotating the batteries
slightly in the computer. If this fails,
contact your local service center.
Pacific Rower Computer screen illuminates,
but does not register when rowing.
Loose or failed connection.
Check that the computer lead is
connected properly. If it is connected
then contact your local service center.
Summary of Contents for WR-P
Page 11: ......
Page 16: ...Parts illustration...
