Watts PWSYS-RO-MAN5, Installation, Operation And Maintenance Manual

Page: 5 / 16

5
STEP 2
Watts Chrome Top Mount
Faucet Installation
Gather and identify the faucet pieces.
Step A - Remove faucet base and faucet spout from their respective
plastic bags . From above the sink, feed the faucet tubing
and toggle bolt down through the 1¼" mounting hole in
the sink . Ensure that the soft rubber gasket is uniformly
positioned in between the base of the faucet and the top of
the sink .
Step B - Align the faucet base so that the handle is on the right side
and the base is sitting flush on the sink top . Turn the handle
down (towards you) to the “ON” position to reveal the
tightening screw (located where the spout will be inserted) .
Using a phillips head screwdriver, turn the screw clockwise
until the toggle bolt secures the faucet base snug onto the
sink top .
Step C - Once the faucet base is securely fastened to the sink top,
insert the faucet spout into the faucet base until it is fully
seated . Turn the handle up (away from you) to the “OFF”
position .
Step D - Locate 3 ⁄
8
" blue tubing in parts bag, connect open end of
the
3
⁄
8
" tubing to the quick-connect fitting located on the
faucet shank .
MiNiMUM MaxiMUM
Mounting Hole Size 1" 1
1
⁄
4
"
Torque on Toggle Bolt 5 lb.in. (max)
Adapt-A-Valve™ Installation
Caution: Water supply line to the system must be from the cold
water supply line only.
Hot water will severely damage your system.
Configuration for
1
⁄
2
inch valve
(using no brass fittings)
Figure 1
Configuration for
3
⁄
8
inch valve
(using brass fittings)
Figure 2
Placement diagram for Adapt-A-Valve™
Figure 3
Step A – Turn off the cold water supply to the faucet by turning the
angle stop valve completely off .
Step B – Attach the Adapt-A-Valve™ as illustrated in Fig 2, Fig 3,
choosing the configuration that fits your plumbing needs .
Step C – Completed Valve installation Figure: 3 .
STEP 3
Figure 1
Figure: 2
Figure: 3
Hot
Supply
Cold
Supply