3
Operating Temperatures Maximum 100°F (37.8°C)
Minimum 40°F (4.4°C)
Operating Pressure
Maximum 1
25
psi
(689 kpa)
Minimum 25psi
(172 kpa)
pH Parameters
Maximum 10
Minimum 5
Flow Rate
1.6 GPM @ 60psi
Operational Parameters
Contents of Under Counter System
1 Filtration System
1 Filter - Attached
1 Parts Bag (blue tubing, brass insert, brass nut, QC stem
adapter, QC union, delrin sleeve, mounting screws)
Tools Recommended for Installation
√ Phillips bit for electric drill
√ Sharp Knife or Scisors
√ 1/2"
Adjustable
Wrench
√ Electric Drill
How to use the Quick-Connect fittings
To make a connection, the tube is simply pushed into the fitting .
Place a piece of tape
1
⁄
2
" from end of tube to indicate how far the
tube should be inserted . The unique patented Quick-Connect lock-
ing system holds the tube firmly in place without deforming it or
restricting flow
Cut the tube square . It is essential that the outside diameter be free of score marks
and that burrs and sharp edges be removed before inserting into fitting .
Fitting grips before it seals . Ensure tube is pushed into the tube stop .
Push the tube into the fitting, to the tube stop . The collet (gripper) has stainless
steel teeth which hold the tube firmly in position while the O-ring provides a perma-
nent leak proof seal .
Pull on the tube to check that it is secure .
Always test the system for leaks
following installation and before use, and periodically during use.
To disconnect, ensure the system is depressurized before removing the tube . Push
in collet squarely against face of fitting . With the collet held in this position, the tube
can be removed .
Do not reconnect. Quick-Connect fitting can be reused only on
a new connection or after existing tube ends are recut free of score marks, burrs
and damage.
Check to confirm that you have all parts. Inspect all parts for
signs of damage, cracks, kinks, wear or breaks. DO NOT USE if
damages in any way. Contact If any of the items are missing
please contact Watts Customer Service for replacement parts.
•
System is intended to be installed on the cold water line
ONLY. Do not use with hot water supply.
• Do not install if your water lines are susceptible to water
hammer.
• System to be used with municipal or well water sources
properly treated and tested on regular basis to insure
suitable and non-adverse water conditions, including
bacteriological safe quality.
