8
Downloading to a USB Flash Drive
Fusion data from an RF-3000LE USB or Rionfuser™ LT Electrofusion Processor is downloaded onto an
external USB flash drive. The data is output in a binary format that is compatible with a free macro-en-
abled Excel Spreadsheet available from Orion Engineering Department.
To download fusion data from the processor to a USB flash drive, perform the following steps:
1. Turn On the processor and allow it to proceed through the INTERNAL SELF TEST until it reaches
the CONNECT LEADS screen.
2. Plug a formatted USB flash drive into the USB host connector on the face of the processor.
3. The USB flash drive will be detected automatically, and the fusion data will be written to the
drive.
4. A progress screen similar to the following will be displayed as the download proceeds:
5. After the download is complete, the processor will return to the CONNECT FITTING screen. You
may now disconnect the USB flash drive from the USB Host Port to resume normal operation.
NOTE:
Only new fusions performed since the last download will be written to the drive.
The USB flash drive must be formatted using FAT or FAT32 with a sector size of 512 bytes.
Rionfuser™ LT
The
Rionfuser™ LT Electrofusion Processor
has a 9 pin D-sub connector instead of a USB host
connector. To download fusion data from a
Rionfuser™ LT Electrofusion Processor
onto a USB
flash drive, you will need a USB to Serial Port adapter. This adapter is available for purchase from
WATTS. One adapter may be used with multiple processors.
The pictures below show a 9 pin D-sub connector and the installed adapter for your reference.
DOWNLOADING DATA
48%
9 Pin D-Sub
Connector
USB Host
Adapter
Installed
