ProtoNode FPC-N34 & FPC-N35 User Manual
CHAPTER 4
– BACnet/IP or Modbus TCP/IP
OMM-0150_B
• 5/20/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
32
of
140
•
Click on the
Use the following IP address
radio button and type in the IP Address.
•
Click the
OK
button twice to complete the process.
4.2 BACnet/IP and Modbus TCP/IP: Setting IP Address for Field
Network
•
After setting your PC to be on the same subnet as the ProtoNode (Section
4.1 ), open
a web browser on your PC and enter the IP Address of the ProtoNode; the default
address is
192.168.1.24
.
•
The Web Configurator will be displayed as your landing page (see Figure 4-1).
•
Below the Active Profiles heading you should see profiles listed for connected devices.
If no profiles are present, then the wiring, baud rate, and DIP switch settings must be
checked, because there is a problem with device communications. All the active
profiles must show the correct Node-
ID’s before proceeding.
•
To access the Web GUI, click on the
Diagnostics & Debugging
button
in the lower-
right side of the page.
Figure 4-1: Web Configurator Screen with Active Profiles
