Modulex Light Commercial Series
CHAPTER 9: Spare Parts Drawings and Lists
OMM-0158_A
• 6/28/2022 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page
109
of
120
Figure 8-21: Lifting Burner Assembly and Location of Check Valve (Step 16)
Figure 8-22: Lift Pins Inserted into Lift Holes, Left and Right Sides (Step 17)
8.11 Cleaning THE BURNER MODULE AND COMBUSTION CHAMBER
After lifting up the burner assembly, the individual burner modules are now exposed and may be
cleaned. Follow the instructions to clean the burner modules.
Figure 8-23: Burner Modules Exposed for Cleaning
1. Carefully lift each burner module from its position. Remove both the module and the gasket.
Discard the used gasket, as each one will be replaced at reassembly.
W A R N I N G !
The burner gaskets
MUST
be replaced at every cleaning.
NOTE:
The check valve
(1 in Figure 8-21)
should at this time be
checked to ensure that
it moves freely and
closes properly.
