Operation & Maintenance Manual
AquaSolve
®
Page 5 of 8
Installation
Tighten the tank head.
Anytime AquaSolve systems are installed above the ground floor
of a building it is recommended that a vacuum relief valve also be
installed to protect against tank collapse in the event the plumb-
ing system is drained. If a vacuum relief valve is not used then the
system should be placed in bypass anytime the plumbing system
is drained. The part number for suggested vacuum relief valve is
92165 (not included). The vacuum relief valve should be installed
on the outlet of the system.
NOTICE
• We recommend the installation of a dual-union ball-valve on
the inlet and outlet to isolate the tank for servicing.
• A full bypass should be installed so that the full service flow
can be routed around the system as needed for servicing.
• The full weight of the plumbing system must be supported by
pipe hangers or other means.
NOTICE
Install Piping
Connect the inlet and outlet plumbing according to
your preferences and any applicable local codes.
Include sample/drain ports with hose-bibb connec-
tions on the inlet and outlet piping to facilitate startup
and service.
Check the head on top of the tank. It’s common for it to loosen
during shipment. Tighten the head with a strap wrench as needed.
NOTICE
Model
Part # Frequency
AM8408-COM-RM
144903
Media should be replaced every
3 years
AM8410-COM-RM
144905
Media should be replaced every
3 years
System Overview
Stainless Steel Head and By-Pass Assembly
Parts List
Item Quantity Part #
Description
1
1
148777
Nickel plated brass inlet/
outlet head
2
2
148779 By-Pass Clips (x2) required
3
2
148780
1” Coupling & O-Ring (x2)
required
4
1
144056 S. S. By-Pass Assembly
5
1
148781
8” x 44” Tank 2.5” Top
(not shown)
6
1
148782
10” x 54” Tank 2.5” Top
(not shown)
Technical Support
• (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
OMM-0155-AquaSolve-AM8408-AM8410
Replacement Media
