Page 12
Blue Tube Connection (From The RO Module To TANK)
Position tank in desired location. Stand it upright or lay it on
its side (using the black plastic stand). Measure the blue tube
(marked “TANK”) from the RO module over to the tank and cut
it to length leaving a straight edge on the end of the tube. Then
insert the tube into the quick connect fi tting on the tank ball
valve. Make sure the tube is pushed in all the way to the tube
stop (see page 11 for quick connect fi tting use directions).
Step 22
Black 3/8” Tube Connection (From FAUCET To The DRAIN SADDLE)
Measure the 3/8” black tube from faucet to the black drain
saddle so that it is as short and straight as possible, then
make a straight cut through tube.
Remove black plastic nut from drain saddle. Slip black tube
through black nut. Insert black tube into the opening in the
drain saddle and tighten the black nut securely.
This is a gravity fed line, if there is any dip or kink in the tube
the rinse water will not fl ow into the drain properly. Water
will back up and come out the air gap hole in the back of the
faucet base.
The tubing must be as SHORT and STRAIGHT as possible, making a downward slope
from faucet to drain saddle to allow for proper drainage.
Step 26
Note:
Note:
Step 25
Step 23
Determine where the 3/8” blue tubing from the faucet and the 1/4”
blue tubing (marked “FAUCET”) from the RO Module would join
together comfortably. Cut the tubes leaving a straight cut on both
tubes. Insert the 1/4” blue tube (marked “FAUCET”) from the RO
module into the 1/4” end of the 1/4” x 3/8” quick connect union
supplied in the parts bag. Make sure the tube is pushed in all
the way to the tube stop.
Blue Tube Connection (From The RO Module To FAUCET)
Step 24
Insert the 3/8” blue tube from the faucet into the remaining 3/8”
open end of the 1/4” x 3/8” quick connect union. Make sure the
tube is pushed in all the way to the tube stop.
