Page 11
Thread the 2 white plastic connectors into the final filter and tighten.
Step 29
To install the 6" filter cut the blue tube from the faucet approximately
in half. Insert the blue tube attached to the faucet into the “out” port
of the filter. The flow arrow should be pointing toward the faucet.
Take the left over section of blue tube and insert it into the other
white connector. Tighten the white compression nuts with a 5/8"
wrench.
Step 30
Slip the brass nut over blue tubing from faucet, then slip the white
Delrin sleeve over the tubing and insert the brass insert into the end
of the blue tubing. (Same as in the Green Tube Connection section.)
Step 31
10" Final Filter Installation
If the system has a 6" final filter, refer to the 6” inch final filter
installation. If the 6" final filter has already been installed skip this
section.
Remove the 2 blue caps from the 10" final filter and attach a plastic
connector to each end of the filter.
Step 33
Snap the 2 white clips from the parts bag onto the top of the
membrane vessel. Snap the 10" final filter into the clips.
Step 32
Measure the blue tube from the faucet to the end of the 10" final filter
that the flow arrow points toward. Use a sharp knife to make a
straight cut through the tubing. Insert the tube into the white
connector and tighten with a 5/8" wrench.
Step 34
Insert the tubing into the brass tank tee until it stops. Slide the brass
nut and delrin sleeve along the tube until you can thread the nut onto
the tank tee. Use a ½” open end wrench to tighten the nut securely.
Note:
Summary of Contents for 5 SV DELUXE
Page 19: ...Page 19 California Certification...
Page 24: ...Page 24...
