Wattbike ATOM, User Manual, Page: 6 / 20

06
0 3
S E T U P
The adjustment levers on the Atom are spring loaded, allowing you to pull on the
lever and rotate then release back into place without having to tighten or loosen
the lever.
Use the corresponding levers and adjusters to set up your Atom to your preferred
cycling position. Make all adjustments off the bike.
1. Raise or lower your saddle height using the lever on the rear of the saddle
stem. Loosen the lever to adjust the stem and tighten to secure.
2. Adjust your saddle fore/aft position by using the 4mm Allen key to loosen the
saddle slider. After adjusting, tighten to secure.
3. Set your handlebar height using the lever on the front of the handlebar stem.
Loosen the lever to raise or lower the handlebars. Tighten to secure.
4. Adjust your handlebar fore/aft position using the 5mm Allen key to loosen the
handlebar. After adjusting, tighten to secure.
TIP: We recommend you have your handlebars between 4-10cm lower than
your saddle height.
5. Raise the device mount to slide your device into place, push the mount down
and rotate the red locking rings backwards to secure.
6. Use the rubber feet on the Atom to adjust the height of each corner of the
frame to stabilise the bike.
TIP: We recommend using a Wattbike floor mat under your Atom to protect
the floor or carpet from sweat and fluid.
7. To lower the rubber feet, screw clockwise, to raise the feet screw anti-
clockwise.
8. Visit wattbike.com/bikefit to accurately replicate your road bike figures onto
the Atom.
TIP: Do not only hold onto the arms of the device holder whilst riding, as this
may cause damage to your Atom. Use the Tri-pads or handlebars to rest
your weight and hold onto the handlebars for hard efforts.