13
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
❑
Install the control horn to the left side of the rudder,
making sure that the pushrod attachment holes are positioned
over the rudder hinge line and that the control horn is lined up
with the pushrod wire. The centerline of the control horn should
be approximately 3/8" up from the bottom of the rudder, at the
hinge line.
IMPORTANT
Remember to glue the control horn into place
so that it doesn't come loose during flight.
❑
Center the rudder and the rudder servo horn, then mark
and make a Z-Bend in the pushrod wire.
☞
Remember to remove the pushrod wire from the control
horn and pull the pushrod wire forward so that it's easier to
make the Z-Bend.
❑
Attach the servo horn to the pushrod, then place the servo
horn onto the servo, securing it into place using the retaining
screw provided with your servo mounting hardware.
❑
Carefully install your aileron servo into the aileron
servo tray, as shown. Again, depending on the size of
your servo, you may need to modify the size of the hole to
fit your servo.
Step 3: Installing the Aileron Pushrod Assemblies
❑
Test-fit the servo tray to the wing. When positioned
properly, the base of your servo should be centered within
the cutout in the wing, and the mounting rails on the bottom of
the servo tray should fit flush against the surface of the wing.
The servo output shaft should be toward the leading edge of
the wing, too.
IMPORTANT
Depending on the depth of your servo, the
servo may not sit in the cutout. This is okay. Just make sure
that the servo is centered over the cutout.
❑
When satisfied with the fit and alignment, cut away and remove the covering material from the bottom of the wing
where the servo tray assembly will be glued into place.
