11 EDISON SENIOR RAIL ASSEMBLY INSTRUCTIONS
Leveling the Rail
To level the run of rail segments, loosen the two
set screws on each leg, as shown below. Once
the screws are loosened, the foot will freely spin
and telescope in and out, raising and lowering
that section of rail. When the desired height
is reached, be sure to re-tighten the screws.
PLEASE NOTE - the leg must always be re-
tightened perpendicular to the rail for end-legs,
and perpendicular to the mid-leg assembly for
mid-legs.
Bending the Rail
Once the run is assembled, and power/data is
installed, bend the rails to the desired angles.
The mid-legs can bend 90 degrees in
either direction.
14.
13.