Watson Marlow Pumps 530 En, Installation, Operating And Maintenance Manual

Page: 2 / 132

12.3 Control wiring 24
12.4 N Module and F Module 28
12.5 Input/output connectors 31
12.6 EtherNet/IP™ pump external interface parameters 33
12.7 Network topology 34
13 Switching the pump on for the first time 36
13.1 Selecting the display language 36
13.2 First-time start-up defaults 38
14 Switching the pump on in subsequent power cycles 40
15 Main menu 41
15.1 Security settings 42
15.2 General settings 53
15.3 Change mode 64
15.4 Control settings 64
15.5 Help 66
16 Mode menu 67
17 Manual 68
17.1 Start 68
17.2 Stop 69
17.3 Increasing and decreasing flow rate 69
18 Flow calibration 71
18.1 Setting the flow calibration 71
19 EtherNet/IP™ mode 73
19.1 Configure EtherNet/IP™ settings 73
19.2 EtherNet/IP™ mode 77
19.3 Pump parameters 77
19.4 EDS compatibility guide 90
20 Sensors 91
20.1 Sensor wiring 92
20.2 Setting up the sensors 93
20.3 Start up delay 97
20.4 Generic sensors 99
20.5 Flow sensor reading 110
21 Troubleshooting 111
21.1 Error codes 111
21.2 Technical support 112
22 Drive maintenance 113
23 Drive spares 114
24 Pumphead replacement 115
24.1 720R and 720RE pumphead replacement 115
2 m-730en-en-09 02-02-22