Watnext WatHome20 Series, Instruction Manual

Page: 18 / 32

through the thermostat placed inside the dispenser: the upper part of the
case has to be removed, then it is possible to set the specific black knob
“cooler” from 0 to 7- higher values mean cooler water.
Flow regulation
With a screwdriver the flow regulator placed at the rear of the dispenser
can be set as follows:
• Closing : lower flow and better carbonation
• Opening : higher flow and lower level of carbonation
1. Hermetic carbonator
2. Pump
3. Flow regulator
4. Condensator
5. Electronic board
6. Compressor
7. Vent
8. Evaporator
T. Thermostat
V. Solenoid valve
Management procedures for the dispenser
The dispenser could be equipped with 2 or 3 mechanical faucet,
depending on the type of water supplied. For water supply, simply full the
lever of the faucet towards you. The faucet for sparkling water is equipped
with a compensator to regulate the water flor and guarantee a good level
of carbonation.
In order to prevent malfunctioning of the pump, it is mandatory that the
dispenser runs water in its circuits. Is water supply is missing, a protection
system will stop the pump. The pump stops working after 4 minutes of
continuous work. To recover the functioning of the dispenser, please
unplug the dispenser from power supply and try again when water supply
is back.
1
2
5
4
6
8
7
T
V
3
16